Getting Started With CPLDs – Part 2
Ok so you’ve got your Quartus II software installed and you’re ready to start programming. I should note at this point that I will only be covering the schematic entry method of programming your CPLD....
View ArticleGetting started with CLPDs – Part 3
Before we get stuck in to the build, we need to take a look at resistor values. An LED will suck as much current from the CPLD chip as it can but what if your CPLD can only supply so much? The most...
View ArticleGetting Started with CPLDs – Part 4
In this guide, we’re going to build up from the previous guide and add a button to our LED. Hopefully by now you’ve had a play with the Quartus II software and had a look through some of the logic...
View ArticleBuilding a 4bit / 8bit computer in CPLD
Something we’ve been working towards is building a homebrew CPU from scratch in CPLD. If you’ve seen any of our “Getting Started with CPLDs” guide, you might have noticed that we’re working towards...
View ArticleAtari ST restoration
Here at The Hackshed, we have several “retro” computers. A few of the machines we own are Atari STs. While looking at a couple of them the other day, I found one has a key missing (it was like that...
View Article